Motor Control Wiring Trainer
The ET250 Motor Control Wiring Trainer Panel is intended to demonstrate electrical principles such as low voltage switching, motor starting and control. It also has provisions for extensive switching and connection of motor power at 24 VAC. The trainer has a dual 24 volt power supply that is used to wire and test all circuits.
Includes these major components:
2 Push-button start-stop units
2 Lights to indicate low voltage "ON"
1 Low voltage buzzer
1 Selector switch-dual position
2 DPDT 24 VAC relays
1 Manual starter and switch
2 Four pole NC/NO starter relays
1 Low voltage motor
Dual 24 VAC, 5 Amp panel with breaker
Three wire grounding AC 120V cord

All electrical items are housed in Lexan clear plastic boxes.

The unit is complete with an experiment manual, with the following experiments:
ET250 Table of Contents:
Introduction
The Simple Switch
The Motor Starter
Motor Loads
Complex Switching
The Single-Pole Double Throw Switch
Relay Circuits
Continuity Testing
Start-Stop Switches
Series-Parallel Loads

All of the above components are mounted on a hardwood panel  36"W x 30"D x 27"H.

Input required: 115VAC, at 15 Amps, 50/60 Hz. Also available for 24 VAC output only for use on 220V, 50 or 60 Hz.
12589925                                                    $3,115