Residential Electrical Trainer 
This Trainer Panel is intended to demonstrate and measure electrical currents and voltages similar to found in a residential dwelling. It also has provision for extensive switching and connection of lamps and outlets.

Includes these major components
0-1 Amp. AC ammeter, with circuit breaker 
0-10 Amp. AC ammeter, with circuit breaker 
0-15 VAC AC voltmeter 
0-150 VAC AC voltmeter 
Low voltage push-button "doorbell" switch 
Pilot light to indicate low voltage "ON"
A buzzer
Multi-tap transformer for 4,8,16V & 24 VAC
Two standard duplex receptacles
Two lamp sockets
Pilot light to indicate 120 VAC is "ON"
Two three-way toggle light switches
Standard residential 120 V watt-hour meter
Input master 15 Amp. circuit breaker
Six outlet wiring strip with pilot light
Three wire grounding AC 120 V cord

Condensed Table of Contents:
Introduction
The Simple Switch
The Single-Pole Double-Throw Switch
Continuity Testing
The Voltmeter
The Ammeter
The Ammeter-Voltmeter-Series Switches
Parallel Switches
Series Loads
Parallel Loads
Series-Parallel Loads
The Watt-Hour Meter
Calibrating the Watt-Hour Meter

All of the above components are mounted on a hardwood panel 36"W x 30"D x 27"H. The sloping front panel uses banana jack connection points and the unit includes a quantity of stacking banana interconnecting leads. Input required is 115 VAC, at 15 Amps., 50/60 Hz.
12590012                                        $1,845

Student Lab Manual for the ET500 "Electrical Circuits."
12589781                                        $39.95